I don't really need any more fall cards so I thought I would go with a Christmas card this week and wanted to use this adorable gingerbread die that I discovered in my stash. I had a layout in my mind and die cut quite a few of the gingerbread people but changed my mind and only ended up using 2 so I have lots left over for more cards so perhaps you will see them again soon lol!
Here is my card:
A close up of the gingerbread:
Plus I decorated the inside:
I began by die cutting the gingerbread and all the tiny pieces to decorate them using scrap card from my scraps bin. I assembled them using liquid glue (which was the longest part of the whole card, especially as I originally die cut about 10 of them!). I had a piece of brown dotty paper on my desk left over from another project and thought it matched my gingerbread perfectly. I cut the paper to 3 7/8" x 5 1/8" and added a thin red mat layer behind with double sided tape. I die cut a fish tail banner from some woodgrain pattern paper and again cut another one from red card as a mat layer (I had to trim the pattern paper ever so slightly as I didn't have a nesting banner so used the same one for both layers). I added the banner to my base layer with foam tape and added the gingerbread people with foam squares. I die cut the 'sweet' word 3 times from red card and adhered them together with liquid glue; I then also adhered it to the banner with liquid glue. I stamped a sentiment in red ink and die cut it with a sentiment strip die. I adhered this below the sweet word with a mix of liquid glue and foam tape. Rather than add embellishments I die cut some hearts from the kraft card and added some white gel pen details to make them look a little like heart cookies. I added these around the gingerbread with liquid glue. The panel was then added to my card base with double sided tape. For the inside I cut a white panel 3 7/8" x 5 1/8" and again added a red mat layer with double sided tape. I took a strip of the woodgrain paper and added it to the bottom of the panel with double sided tape and above that adhered a thin strip of red card with liquid glue. I had badly cut one of my gingerbread so decided to cut him in half and added him over the woodgrain paper with liquid glue. I also added one of the heart cookies. I stamped a sentiment in black ink in the centre of the panel and this was then added to my card base with double sided tape. A really fun card and I'm really happy with it. I hope you like it too.
I would like to enter my card into the following challenges:
* to be updated *
I'll be back tomorrow with my card for the Krafty Chicks challenge so I hope you will pop back and check it out. Until then enjoy the rest of your day and thank you so much for stopping by.
Love and hugs,
card ingredients:
Spellbinders - stocking full of joy die set (for gingerbread) - retired
Spellbinders - sweet treat box die set (for sweet word)
Spellbinders - holiday besties clear stamp (for inside sentiment)
MFT - tag builder blueprints 6 (for hearts)
MFT - blueprints 13 (for fishtail banner) - retired
MFT - my itty bitty holiday clear stamp (for outside sentiment) ? retired
Gina K Designs - sentiment strips dies
Gina K Designs - warm cocoa ink pad (to add dimension to my gingerbread)
Gina K Designs - red hot ink pad
Limetree Crafts - 250gsm smooth white card (not currently available)
Patterned paper from a pad I bought in TK Maxx
red and kraft card from scraps bin
Versafine - onyx black ink pad
No comments:
Post a Comment